If you're like most people, chances are that your current intake piping is held together by a random assortment of rubber couplers and coolant hoses purchased on EBay or at a hardware store. Rubber parts, or silicone parts without reinforcement, can create boost leaks and always tend to fail at the worst possible time. They also are not designed to stand up to the heat and pressure created in a modified turbo intake. By using these reinforced silicone couplers, you can be certain that your intake is reliable and free of leaks.

This kit also includes our high-quality Stainless Steel T-Bolt Clamps. Worm gear clamps like you buy at a hardware or auto parts store can damage your intake couplers. They often break when you tighten them, and they can't be tightened enough to hold couplers on pipes during moments of high boost. Upgrade to this kit now to make sure everything stays together like it's supposed to.

High quality 3-ply or 4-ply fabric reinforced silicone
Installer can cut silicone parts down to fit with a razor
Heat tolerance: -40° to 392° Fahrenheit
Burst Pressure: 200 PSI
Working Pressure: 50 PSI
Wall Size: 4 mm - 5 mm

The clamps are smooth on the inside and will not bite into silicone like worm gear clamps.
Clamping ability is over 20 times greater than worm gear clamps.
Bolt is easy to tighten since it is out away from the clamping surface.
Clean, shiny, and professional looking - show quality clamps.
Do not get dirty as easily as worm gear clamps, and are easier to clean.

Kit Contents:

8 Silicone Couplers
16 T-Bolt Clamps of the appropriate size